19 answers, written the same way we would answer you on WhatsApp.
Yes. Active leaks, burst pipes and flooding are treated as emergencies and attended outside normal hours wherever our schedule allows. Call us first and we will talk you through isolating the supply while the team is dispatched.
In most cases, yes. Thermal imaging and acoustic detection locate concealed leaks accurately enough that we can open a single small, precise access point rather than exploring destructively.
The usual causes are a partially closed or failing isolation valve, scale build-up restricting the supply line, a clogged filter or pressure-reducing valve, or a leak somewhere on the incoming main. We test zone by zone to isolate which.
If the tank itself has corroded or is leaking, replacement is the only sensible option. If the fault is the element, thermostat or a heavy scale build-up, repair and descaling will usually give several more years of service. We will tell you honestly which situation you are in.
Yes. We carry out phased re-pipes so the property stays habitable, replacing failed galvanized or corroded lines with PPR or PEX, and we reinstate all wall and ceiling finishes as part of the contract.
Yes, and it is priced into the original quotation. Openings are patched, skimmed and repainted to match the surrounding finish as a standard part of the job.
A repeatedly tripping breaker is either an overload, a genuine earth fault or a failing device. We test the circuit under load, use insulation resistance testing to find the fault and repair the cause. Replacing the breaker with a larger one is never the answer.
If your board has rewireable fuses, no residual current protection, or is full with no spare ways, an upgrade is strongly advised. Modern RCBO protection isolates only the faulty circuit rather than plunging the whole property into darkness.
Yes. We assess the incoming supply capacity, run a dedicated protected circuit, install the charge point and test and certify the installation, including coordination with the authority where approval is required.
Yes, both full and partial. Rewiring is phased so the property remains usable, and all chasing, patching and redecoration is included in the scope rather than left for you to arrange.
Yes. Every installation is tested and you receive a written record of the results along with an updated circuit schedule for the distribution board.
Yes. We carry out lighting design for villas and apartments, covering layer, color temperature and control, and install everything from recessed downlights and cove lighting to feature and landscape schemes.
Detection and repair starts from AED 449. The figure depends on access and on how much reinstatement is required, and you get a fixed written quotation before we start.
Very much so. Underground irrigation leaks, leaking flush valves and leaks into a drainage void can all consume large volumes with no visible sign. Run the meter test; it will settle the question quickly.
Policies differ, but most UAE home policies cover the resulting damage rather than the failed pipe itself. Photograph everything before work starts, and keep the written report; insurers ask for both.
No. Each reset re-energizes the fault. If a breaker trips twice in a row, leave it off and have the circuit tested.
Moisture reduces insulation resistance, so leakage current rises past the RCD's threshold. It points to water ingress at an outdoor accessory, a light fitting or a water heater.
Never. The cable buried in your wall is sized to the original rating. A larger breaker allows the cable to overheat before the device disconnects, which is precisely how electrical fires start.
Electrical fault finding and repair starts from AED 349, including systematic testing and a written record of results. You receive a fixed quotation before any remedial work begins.
Message us on WhatsApp. We answer every one, and the good questions end up on this page.
